That is correct, it will not disengage. I think the inward side should go in, and the bolts should be tightened down for the springs--4. But I put the inward side in(shown in the figure above) and did not fully tighten down the spring bolts. So many details, I could not decide which side goes down, and if the cam spring plate was tightened too far down(more towards the center of the motorcycle) the cover clutch push rod does not even reach it! I now believe that to be false. Perhaps I have to turn the spring cover around so the mounting can occur on the four threaded holes attaching it to the outside clutch cage, tightly, and then still be reached by the little rod that pushes the clutch cover inward when you pull it in on the left handle bar. !!!??? Robert -------------------------- PS I rode it around the block several times, but it did not free up. I shifted without the clutch. ---------------------------------
On Wednesday, July 1, 2015 at 5:48:06 PM UTC-5, Allen wrote: > > are you saying it will not disengage? If so that is an adjustment issue > with the cable. > > On Tue, Jun 30, 2015 at 7:37 PM, Robert Kariniemi <[email protected] > <javascript:>> wrote: > >> I may have to, soak overnite, as coating them with oil was not enough. >> Still no sign of slipping, even when fully pulled in at handlebar. >> Robert >> >> >> On Tue, Jun 30, 2015 at 5:52 PM, Allen Thomas <[email protected] >> <javascript:>> wrote: >> >>> Normally I soak them in oil overnight. >>> >>> Allen Thomas >>> >>> -- >>> You received this message because you are subscribed to the Google >>> Groups "Nighthawk Motorcycle Lovers!" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected] <javascript:>. >>> To post to this group, send email to [email protected] >>> <javascript:>. >>> Visit this group at http://groups.google.com/group/nighthawk_lovers. >>> For more options, visit https://groups.google.com/d/optout. >>> >> >> -- >> You received this message because you are subscribed to the Google Groups >> "Nighthawk Motorcycle Lovers!" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> To post to this group, send email to [email protected] >> <javascript:>. >> Visit this group at http://groups.google.com/group/nighthawk_lovers. >> For more options, visit https://groups.google.com/d/optout. >> > > -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/nighthawk_lovers. For more options, visit https://groups.google.com/d/optout.
