Hi,
I am trying to setup a test but I am not sure the setup is valid.
What I want to do, is have multiple Vlans being controlled by the same
controller, so that we can switch packets between different Vlans.
We have an HP switch. After creating the Vlans, we pointed each vlan
to the same controller. What I see in the controller is that the switch
registers for a specific Vlan, and when it tries to register again for
a different Vlan it uses the same dpid and thus unregister and registers
for the other Vlan(i.e. for a separate set of ports). Each switch, at
any point in time is registered for only one Vlan.
Is this the intended behavior, or there is misconfiguration somewhere?
It seems that it should be possible that the same controller, can
control different Vlans, somehow ....
Thanks,
Niky Riga
_______________________________________________
nox-dev mailing list
[email protected]
http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
