Hi Srini, I thought your patch resolved this? Is this the discovery patch that I am sitting on?
Regards KK On 18 June 2010 08:38, Srini Seetharaman <[email protected]> wrote: > This is a problem caused because NOX uses only the 48 least > significant bits of the datapathid, and in HP switches the datapathid > of each VLAN differs only in the most significant bit. Jean (HP) might > be able to provide a firmware to bypass this issue. > > On Fri, Jun 18, 2010 at 8:23 AM, Niky Riga <[email protected]> wrote: >> Hi, >> >> I am trying to setup a test but I am not sure the setup is valid. >> What I want to do, is have multiple Vlans being controlled by the same >> controller, so that we can switch packets between different Vlans. >> >> We have an HP switch. After creating the Vlans, we pointed each vlan >> to the same controller. What I see in the controller is that the switch >> registers for a specific Vlan, and when it tries to register again for a >> different Vlan it uses the same dpid and thus unregister and registers for >> the other Vlan(i.e. for a separate set of ports). Each switch, at any point >> in time is registered for only one Vlan. >> >> Is this the intended behavior, or there is misconfiguration somewhere? >> >> It seems that it should be possible that the same controller, can control >> different Vlans, somehow .... >> >> Thanks, >> Niky Riga >> >> _______________________________________________ >> nox-dev mailing list >> [email protected] >> http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org >> > > _______________________________________________ > nox-dev mailing list > [email protected] > http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org > _______________________________________________ nox-dev mailing list [email protected] http://noxrepo.org/mailman/listinfo/nox-dev_noxrepo.org
