Install the drivers, shut down, install the FW, reboot.
-----Original Message----- From: Lum, David [mailto:[EMAIL PROTECTED] Sent: Tuesday, March 25, 2003 11:16 AM To: NT 2000 Discussions Drivers BEFORE the firmware? I'd have figured the opposite. Dave Lum - [EMAIL PROTECTED] Sr. Network Specialist - Textron Financial 503-675-5510 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: Tuesday, March 25, 2003 10:30 AM To: NT 2000 Discussions Subject: Re: Updating Scsi Firmware On Tue, 25 Mar 2003, at 11:54am, [EMAIL PROTECTED] wrote: > I have a Dell PowerEdge 2400 that has a Perc 2/si SCSI controller in it. I > want to update the firmware on the card from 2.1 build 2881 to v. 2.7.1. > build 3571. Do I have to worry about losing the config on the card? The config should live through a firmware update. > Also I need to update NT Drivers for the Card. Should I do this before I > update the firmware on the SCSI card or after the card has been flashed > and boot back into the OS. The general rule is, drivers first, then firmware. Check the release notes first for any exceptions. As always: Have multiple, verified, tested backups, and update your Emergency Repair Disk, before doing anything. -- Ben Scott <[EMAIL PROTECTED]> | The opinions expressed in this message are those of the author and do | | not represent the views or policy of any other person or organization. | | All information is provided without warranty of any kind. | ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to %%email.unsub%% ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to %%email.unsub%% ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED]
