did this occurred immediatly after the first install ? GuidoElia HELPPC
_____ Da: Gavin Wilby [mailto:[EMAIL PROTECTED] Inviato: domenica 30 marzo 2008 16.55 A: NT System Admin Issues Oggetto: SBS help Hi, I have bought a new HP ML110 server. It has been installed with a retail version of SBS2003 standard. I have had to rebuild the server once because of the same fault that it is now exibiting. I have tracked it down to a few points. DNS service will start, but refuses to load the dns zones and gives the following error. "The DNS server was unable to open Active Directory. This DNS server is configured to obtain and use information from the directory for this zone and is unable to load the zone without it. Check that the Active Directory is functioning properly and reload the zone. The event data is the error code." This in turn makes the server unable to act as a server. Other events in the logs are: Process INETINFO.EXE (PID=1460). Topology Discovery failed, error 0x80040931. The Security System detected an authentication error for the server STOOF\HEX$. The failure code from authentication protocol Kerberos was "The attempted logon is invalid. This is either due to a bad username or authentication information. (0xc000006d)". The internal domain is stoof.local and the sbs server is called Hex. The server has not been changed in anyway but this is now the 2nd time its happened and I cannot figure out whats going on with it. ~ Upgrade to Next Generation Antispam/Antivirus with Ninja! ~ ~ <http://www.sunbelt-software.com/SunbeltMessagingNinja.cfm> ~
