Hi, Nope it was up for about 4 days before it occured. All drivers are completly up to date.
On Sun, Mar 30, 2008 at 5:37 PM, HELP_PC <[EMAIL PROTECTED]> wrote: > did this occurred immediatly after the first install ? > > *GuidoElia* > *HELPPC* > > > ------------------------------ > *Da:* Gavin Wilby [mailto:[EMAIL PROTECTED] > *Inviato:* domenica 30 marzo 2008 16.55 > *A:* NT System Admin Issues > *Oggetto:* SBS help > > Hi, I have bought a new HP ML110 server. It has been installed with a > retail version of SBS2003 standard. I have had to rebuild the server once > because of the same fault that it is now exibiting. I have tracked it down > to a few points. DNS service will start, but refuses to load the dns zones > and gives the following error. "The DNS server was unable to open Active > Directory. This DNS server is configured to obtain and use information from > the directory for this zone and is unable to load the zone without it. Check > that the Active Directory is functioning properly and reload the zone. The > event data is the error code." This in turn makes the server unable to act > as a server. Other events in the logs are: Process INETINFO.EXE(PID=1460). > Topology Discovery failed, error 0x80040931. The Security System > detected an authentication error for the server STOOF\HEX$. The failure code > from authentication protocol Kerberos was "The attempted logon is invalid. > This is either due to a bad username or authentication information. > (0xc000006d)". The internal domain is stoof.local and the sbs server is > called Hex. The server has not been changed in anyway but this is now the > 2nd time its happened and I cannot figure out whats going on with it. > > > ~ Upgrade to Next Generation Antispam/Antivirus with Ninja! ~ ~ <http://www.sunbelt-software.com/SunbeltMessagingNinja.cfm> ~
