What policies do you have between the two offices? In addition to setting up the tunnel, you need to have a policy that says what traffic can pass over the VPN. That should have been setup automatically if you used the VPN creation wizard, but can be set manually as well.
*ASB *(My XeeSM Profile) <http://XeeSM.com/AndrewBaker> *Providing Competitive Advantage through Effective IT Leadership* On Tue, Oct 20, 2009 at 9:44 AM, Cameron <[email protected]> wrote: > Good morning all! > > Hardware - Juniper SSG-5 > > Situation - I've configured the firewall and can ping any internet IP and > surf just fine. I've created VPN tunnels to our head office from the remote > site and the tunnels come up fine (showing up on both ends) and yet I can't > pass any traffic through to either side. I can ping the public IP of the > firewalls no problem from the CLI on both sides. In place is the default > policy (Trust -> Untrust, Any, Any, Permit...and also put in place (temp!) > Untrust -> Trust, Any, Any, Permit). I spent well over 2 hours on the phone > with the Juniper Tech Support and they didn't get any further then I did. I > tried 2 brand new firewalls and got the same result on both. > > Any suggestions would be greatly appreciated as always! > > Cheers, > Cameron > > > > > > ~ Finally, powerful endpoint security that ISN'T a resource hog! ~ ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/> ~
