Folks, I am converting our network from point to point to MVLS/Metro Ethernet. What I am noticing at some sites is that performance is worse that with the point to point circuit. Ping times greatly increased, collisions, etc. I've been working with my provider to get this resolved. First they thought it was a speed mismatch issue, so the provider's equipment and my equipment were changed to the same setting (full 100). That's not working and now we'll probably change it to full 10 (since the allocation is 5 Mbps anyway). I can also do some rate shaping on my switches, but it's a PITA and I was hoping to avoid it. Anyone else have these issues with conversion? Some sites are fine, others are not. All have same switches, model, firmware, config for trunk ports. I haven't pulled out my bag o software to look at what's on the pipe, anyone have any that would be best for this scenario? I have Praesser but I really need a site to site test/analysis tool. I just downloaded Qcheck and will see if that does it. I've also asked my provider to give me some statistics on traffic they see. Recommendations and comments welcome. Tom Miller Engineer, Information Technology Hampton-Newport News Community Services Board 757-788-0528 Confidentiality Notice: This e-mail message, including attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure, or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.
~ Finally, powerful endpoint security that ISN'T a resource hog! ~ ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/> ~ --- To manage subscriptions click here: http://lyris.sunbelt-software.com/read/my_forums/ or send an email to [email protected] with the body: unsubscribe ntsysadmin
