Yes it does but I swear I used to have both the point cloud and then I could see trackers overlayed at the same time. Randy S. Little http://www.rslittle.com <http://reel.rslittle.com>
On Wed, Mar 23, 2011 at 14:51, Ivan Busquets <[email protected]> wrote: > Not sure if this is what you're after, but if you need to select a point > from the PointCloud, and get its coordinates (or put an Axis in there), you > can do the following: > > While on the 3D view, activate "vertex selection mode", select the point(s) > in the cloud that you're interested in, and then use the "Snap menu" of an > Axis, Card, etc... to "Translate" it to that position. > > If you were after the 2d coordinate and not the 3d one, just run the Axis > through a Reconcile3D. > > Hope that helps > > Cheers, > Ivan > > > On Wed, Mar 23, 2011 at 12:09 PM, Randy Little <[email protected]>wrote: > >> selecting prediction. I thought there was a way to Select the points >> from the point cloud from the tracker. I know I can select tracks by >> viewing the tracker but I want to select the predictions since there are >> more of them and they are in the spots that I would like them to be in. >> Isn't there a simple way to do this? I thought I just viewed the render >> and made sure the point cloud node was loaded but thats not seeming to >> work. >> >> >> Randy S. Little >> http://www.rslittle.com <http://reel.rslittle.com> >> >> >> >> _______________________________________________ >> Nuke-users mailing list >> [email protected] >> http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users >> >> > > _______________________________________________ > Nuke-users mailing list > [email protected] > http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users > >
_______________________________________________ Nuke-users mailing list [email protected] http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
