I tried this : [r...@ibolya ~]# upscmd -l liebertg...@localhost Instant commands supported on UPS [liebertgxt2]:
The command list is empty. Why? 2010/7/15 Robert Jobbagy <[email protected]> > > > 2010/7/14 Arjen de Korte <[email protected]<nut%[email protected]> > > > > Citeren Robert Jobbagy <[email protected]>: >> >> Here are the steps that occur when a critical power event happens: >>> >>> 1. The UPS goes on battery >>> >>> 2. The UPS reaches low battery (a "critical" UPS) >>> >>> 3. The upsmon master notices and sets "FSD" - the "forced shutdown" >>> flag to tell all slave systems that it will soon power down the load. >>> >>> >>> But If I use my ups with nut on Battery when UPS don't send LB event just >>> do >>> Output OFF and kill PC and after itself. >>> >> >> I have no idea what you're trying to say here. Please explain in little >> more detail what you're trying to ask. The 'upsmon' client will only start a >> shutdown if it sees both the OB LB flags. In the absence of a functional >> upsdrv_shutdown, this is all NUT will do. The liebert-esp2 driver does not >> have either a upsdrv_shutdown and/or functional instcmd's at the time of >> this writing. If your UPS happens to kill the power (at any time), it is >> doing this all by itself. There is currently nothing NUT can do about that. >> See also the previous messages in this thread. > > > It's not important anymore, because battery of other Liebert ups is > wrong. > Liebert-esp2 driver works fine with my ups. > >> >> >> I don't understand when or why called the upsdrv_shutdown function? >>> >> >> This is called when you run a driver with the '-k' flag on the command >> line (or by running 'upsdrvctl shutdown', which will do this for all >> configured drivers). Typically this is done in the system halt script just >> before the system powers down (see also the INSTALL file). > > > Thanks your answer. > > >> >> >> Please someone tell me what happens if UPS works on battery and I use >>> NUT. >>> >> >> See above. >> >> >> Best regards, Arjen >> -- >> Please keep list traffic on the list >> >> >> _______________________________________________ >> Nut-upsdev mailing list >> [email protected] >> http://lists.alioth.debian.org/mailman/listinfo/nut-upsdev >> > > I tested my ups with liebert-esp2 driver and use it ON Battery and if ups > status will be LB then shutdown the PC but if power back > then PC stay power off. > How can I configure nut that if power back then PC start automatic ? > > Thanks your advice. > > > > -- > Best Regards, > > Robert > -- Best Regards, Robert
_______________________________________________ Nut-upsdev mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsdev
