|
Hi all, I just bought a Trust 1000VA PW-4105 UPS. I installed the UPS on FreeBSD 6.1, and installed NUT
2.0.3 via the FreeBSD port. I had no problems installing and configuring nut and the
UPS to run with the PowerMust driver. My problem however is when I test the powerdown function
by issuing the command: ‘upsmon -c fsd’ The UPS is cutting the power before the shutdown
procedure of FreeBSD is done. I have added the following to /etc/rc.shutdown: if (test -f /etc/killpower) then echo
"Killing the power, bye!"
/usr/local/libexec/nut/upsdrvctl shutdown fi I dropped the sleep command, as it doesn’t have
the desired effect on FreeBSD. After looking in the mailing list archives I found
out that you can add a delay on the powerdown for some UPS. My UPS is using the PowerMust driver, and I could not
find any such directive to put in the ups.conf for that driver. I have tried to set the variable ups.delay.shutdown
to 20, but it didn’t have any effect on the powerdown. In the UPS COMMANDS section of the driver man page it
says: ups.delay.shutdown
Interval to wait after shutdown with delay command (seconds) # upsc [EMAIL PROTECTED] battery.charge: 96.3 battery.voltage: 27.1 battery.voltage.nominal: 24.0 driver.name: powermust driver.parameter.port: /dev/cuad0 driver.version: 2.0.3 driver.version.internal: 1.1 input.voltage: 222.4 input.voltage.fault: 222.8 input.voltage.maximum: 224.8 input.voltage.minimum: 216.6 output.frequency: 50.0 output.voltage: 219.9 output.voltage.target.battery: 230.0 ups.delay.shutdown: 20 ups.delay.start: 30 ups.load: 30.0 ups.mfr: Mustek ups.model: PowerMust ups.serial: unknown ups.status: OL I have been google’ing a lot, but haven’t
been able to find at solution to the problem. Is it at all possible with the PowerMust driver? Any help I very much appreciated. Thank you Regards, Johan Pramming |
_______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
