On Tue, 2007-09-25 at 09:18 +0200, Arjen de Korte wrote: > >> i just wonder, if it is posible to read the values for all the three > >> phases of a mge galaxy 6000 ups? > > From looking at the mgemib part of the snmp-ups it doesn't read the data > > of all 3 phases (yet). Though this should be fairly easy to add. > I have added this in my local copy for the MGE MIB, so it could work. excellent... is there any driver that you dont enhance? ;-)
> Could you send that patch again? As far as I know, I committed all patches > you sent, so it could be that I missed one. no problem > They probably never will support it in the same way as other NUT drivers > do. This is because by the time we run 'upsdrvctl shutdown', we won't have > networking capabilities anymore. So the only way to shutdown a SNMP UPS is > by sending it an instcmd "shutdown.(return|stayoff|reboot)". This requires > careful planning, as you want to make sure that the system you send this > command from, has enough time to shutdown cleanly. You can either do this > by allowing sufficient delay before the shutdown, or powering it from an > alternative power source. Neither of these is without risk, so we must > consider this carefully. I was about to evaluate the use of a sufficient delay... once I have a maintenance window on my boxes I'll test that. The last scheduled power-outage was so short that the upsen didn't come anywhere near a shutdown... ;-) Bernd _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
