just to complete my previous request... 2009/7/7 Arnaud Quette <[email protected]>
> Hi Richard, > > 2009/7/6 Richard Scobie <[email protected]> > >> I have been running a Smart-UPS RT 3000 VA using nut successfully over the >> 940-0095B cable for a couple of years. >> >> I have just received a second unit, but it is slightly different in 3 ways >> that I have found so far. >> >> 1. It's a Smart-UPS RT 3000 XL >> >> 2. The 940-0095B cable now uses an RJ45 connector at the UPS end. >> > > if you have the cable schema, I can post it on the cable section of the > website... > > >> 3. It now requires a baud rate of 9600 instead of the 2400 used >> previously. >> >> Can anyone tell me if modifying drivers/apcsmart.c >> >> void upsdrv_initups(void) >> { >> char *cable; >> >> upsfd = ser_open(device_path); >> ser_set_speed(upsfd, device_path, B2400); >> >> to >> >> void upsdrv_initups(void) >> { >> char *cable; >> >> upsfd = ser_open(device_path); >> ser_set_speed(upsfd, device_path, B9600); >> >> all that is required in order to get nut to talk to it, or will other >> things need changing? >> > > yep, that should be sufficient. have you tried this change? > I can check for automating this detection but I need a driver debug output > to validate it first. > can you send me the result of: > /path/to/apcsmart -DDD -a <upsname> > both with and without your change applied. Arnaud
_______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
