When you run lilo, make sure you choose the lilo.conf that works for a hard drive (I think it was /etc/lilo-standard-hda.conf). That way, lilo will not output to serial.
Sameer
--
Dr. Sameer Verma, Ph.D.
Asst. Professor of Information Systems
San Francisco State University
San Francisco CA 94132 USA
http://verma.sfsu.edu/
Barry Murphy wrote:
I thought perhaps the problem was that pebble is designed to output to serial rather than graphics, so perhaps if I get a old 9pin serial port on the machine I can test my theory.
Barry
-----Original Message-----
From: Michael Stearne [mailto:[EMAIL PROTECTED] Sent: Saturday, 22 May 2004 4:40 a.m.
To: Barry Murphy
Cc: [EMAIL PROTECTED]
Subject: Re: [nycwireless] Pebble on old pc and high load averages 1.00
1.00 0.99
On May 20, 2004, at 9:54 PM, Barry Murphy wrote:
Hi,
I have pebble running on 3 soekris net4521 machines for wireless nodes, however when dameontools is running it seems that I have 100% cpu usage, so if anyone has run into this problem before please let me
know.
Secondly, I have 3 x P100 and 1 x P200 machines lieing around. I have purchased a couple of CF -> IDE adaptors to shove in the machines and tried to boot pebble. It gets as far as Uncompressing Linux... Ok, booting the kernal. No Further.
How can I get pebble to run on a old pc ?
I've had this problem with Pebble also. The Num Lock and Scroll Lock lights just blink. I've tried it on a newer dual processor machine but also on an old Pentium 100. I haven't had time to play around with it but should be getting back to it.
For the list: Are there any recommended hardware configurations for Pebble?
Thanks, Michael
--
NYCwireless - http://www.nycwireless.net/
Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/
Archives: http://lists.nycwireless.net/pipermail/nycwireless/
-- NYCwireless - http://www.nycwireless.net/ Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/ Archives: http://lists.nycwireless.net/pipermail/nycwireless/
