Hello, Can you think of a reason why IPoIB-CM code that creates a receive QP [create_qp()] which references a SRQ (create_qp.h_srq = shared_rx_queue_qp_h) would always succeed when run over an Infinihost HCA, while the very same code always fails when run over a ConnectX HCA? Same win2kR2 x64 OS base, same hardware platform except different HCAs; A single HCA per system.
The failing create_qp() return code is IB_INVALID_PARAMETER. First and subsequent create_qp() calls always fail for ConnectX (MT26418, firmware 2.7.0)? All QP parameters are far less than supported CA maximums. Again, the very same code/driver/bits works fine for Infinihost MT25208 and fails on MT26418. Any ideas? thanks, stan. _______________________________________________ ofw mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
