Can you enter the code and see where the failure comes from? If I understand correctly it comes from the create_qp code.
Thanks Tzachi > -----Original Message----- > From: Smith, Stan [mailto:[email protected]] > Sent: Friday, November 19, 2010 10:47 PM > To: Tzachi Dar > Cc: [email protected] > Subject: SRQ attached qp creation fails for connectX and OK for > Infinihost? > > Hello, > Can you think of a reason why IPoIB-CM code that creates a receive QP > [create_qp()] which references a SRQ (create_qp.h_srq = > shared_rx_queue_qp_h) would always succeed when run over an Infinihost > HCA, while the very same code always fails when run over a ConnectX > HCA? > Same win2kR2 x64 OS base, same hardware platform except different HCAs; > A single HCA per system. > > The failing create_qp() return code is IB_INVALID_PARAMETER. > > First and subsequent create_qp() calls always fail for ConnectX > (MT26418, firmware 2.7.0)? > All QP parameters are far less than supported CA maximums. > > Again, the very same code/driver/bits works fine for Infinihost MT25208 > and fails on MT26418. > > Any ideas? > > thanks, > > stan. _______________________________________________ ofw mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
