VID does not control the timeout of the actual vnf operations in mso, so even if vid times out you can close the model window and check the status of it in the vid page for that service instance.
I don't think mso has a timeout, it will continue until something fails so checking mso for more logs about what failed (starting on the vid gui) is a good next step. Thanks, Daniel Rose ECOMP / ONAP com.att.ecomp 732-420-7308 From: onap-discuss-bounces at lists.onap.org [mailto:[email protected]] On Behalf Of Mike Evans via onap-discuss Sent: Friday, April 21, 2017 3:10 AM To: onap-discuss at lists.onap.org Subject: Re: [onap-discuss] Deployment timeout Is there any way to change the value directly in the data model rather than via the GUI? I've had a look at the various resources exposed on the A&AI data model and can't see anything relevant there. At the moment I can't launch Clearwater under ONAP as it times out every time. VID issues the command to launch the VF module, then polls for status 7 times then gives up displaying the "Maximum number of poll attempts exceeded" error message, and, I think, cancels the openstack stack create operation. Mike From: FREEMAN, BRIAN D [mailto:[email protected]] Sent: 20 April 2017 13:54 To: Mike Evans <mike at metaswitch.com<mailto:mike at metaswitch.com>> Cc: onap-discuss at lists.onap.org<mailto:onap-discuss at lists.onap.org> Subject: RE: Deployment timeout I suspect one of those things we didn't change when we reduced SDC to run on a single VM instead of the complex of VM's in production. From: onap-discuss-bounces at lists.onap.org<mailto:onap-discuss-bounces at lists.onap.org> [mailto:[email protected]] On Behalf Of Mike Evans via onap-discuss Sent: Thursday, April 20, 2017 8:45 AM To: onap-discuss at lists.onap.org<mailto:onap-discuss at lists.onap.org> Subject: [onap-discuss] Deployment timeout Is there any way to change the deployment timeout? I've got as far as launching a Clearwater deployment in ONAP, but it's a pretty complex VNF (12 VMs for the base module) and the default 60 second timeout expires when it only a third of the way through. I've gone back to service designer and the timeout appears when importing a VSP as a VF (in the table of Deployment Artifacts) but I can't see a way to view it in the VSP or edit it in the VF. Thanks, Mike -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.onap.org/pipermail/onap-discuss/attachments/20170421/758a16b0/attachment-0001.html>
