Hi, Mike-
VID polls MSO for status and if MSO doesn't finish in time it does not cancel
the operation.
A couple of things you can do -
1) Change the polling interval to have VID wait longer, when you start the
VID docker image set this var to a higher number (default 10000ms)
-e MSO_POLLING_INTERVAL_MSECS <msec>
2) You can go refresh the View/Edit screen periodically refresh the
screen to see if the VF Module was create in A&AI
Thanks,
Jimmy Forsyth
From: onap-discuss-bounces at lists.onap.org
[mailto:[email protected]] On Behalf Of Mike Evans via
onap-discuss
Sent: Friday, April 21, 2017 3:10 AM
To: onap-discuss at lists.onap.org
Subject: Re: [onap-discuss] Deployment timeout
Is there any way to change the value directly in the data model rather than via
the GUI? I've had a look at the various resources exposed on the A&AI data
model and can't see anything relevant there.
At the moment I can't launch Clearwater under ONAP as it times out every time.
VID issues the command to launch the VF module, then polls for status 7 times
then gives up displaying the "Maximum number of poll attempts exceeded" error
message, and, I think, cancels the openstack stack create operation.
Mike
From: FREEMAN, BRIAN D [mailto:[email protected]]
Sent: 20 April 2017 13:54
To: Mike Evans <mike at metaswitch.com<mailto:mike at metaswitch.com>>
Cc: onap-discuss at lists.onap.org<mailto:onap-discuss at lists.onap.org>
Subject: RE: Deployment timeout
I suspect one of those things we didn't change when we reduced SDC to run on a
single VM instead of the complex of VM's in production.
From: onap-discuss-bounces at lists.onap.org<mailto:onap-discuss-bounces at
lists.onap.org> [mailto:[email protected]] On Behalf Of Mike
Evans via onap-discuss
Sent: Thursday, April 20, 2017 8:45 AM
To: onap-discuss at lists.onap.org<mailto:onap-discuss at lists.onap.org>
Subject: [onap-discuss] Deployment timeout
Is there any way to change the deployment timeout? I've got as far as
launching a Clearwater deployment in ONAP, but it's a pretty complex VNF (12
VMs for the base module) and the default 60 second timeout expires when it only
a third of the way through.
I've gone back to service designer and the timeout appears when importing a VSP
as a VF (in the table of Deployment Artifacts) but I can't see a way to view it
in the VSP or edit it in the VF.
Thanks, Mike
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.onap.org/pipermail/onap-discuss/attachments/20170421/1cb49285/attachment.html>
