That did not change the outcome, but my workaround appears to be functioning without a problem.
I also just tested the public interface and had the same problem, only this time when the page was requesting the cgi is was looking for pub. I looked, no pub cgi, but there was a pki cgi. copied that to pub and it works fine. Ron ----- Original Message ----- From: "Massimiliano Pala" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, July 26, 2002 1:31 PM Subject: Re: [Openca-Users] OpenCA .0.9 - RA install > Ron Gedye wrote: > > I've got the CA up and running and through most all it's paces, looks good. > > > > When Installing the RA I ran into a problem. > > I did the configure with all the flags I could find that were necessary, did > [...] > > Am I missing a config somewhere or is this correct? I am just beginning to > > test at this point. Is my workaround workable? > > Do you have also made: > > $ make install-ra > $ make install-online > $ make install-pub > > Let me know. These will install the components you seems to be missing. > > -- > > C'you, > > Massimiliano Pala > > --o----------------------------------------------------------------------- -- > Massimiliano Pala [OpenCA Project Manager] [EMAIL PROTECTED] > [EMAIL PROTECTED] > http://www.openca.org Tel.: +39 (0)59 270 094 > http://openca.sourceforge.net Mobile: +39 (0)347 7222 365 > ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Openca-Users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/openca-users
