Hello all, I was trying to be a good doobie and install the new openprotect version as I had a few minutes and then was going to do some more config file work.
Of course I was not paying attention and I now have a problem. I had a missing perl module , IO-stringy 2.108, followed directions (ALMOST) , did the perl install and installed version 2.109 instead of 2.108. SOOO,, OpenProtect-install then stops the install again and I realize what I have done. I try to install 2.108 "over the top" of 2.109 because I have no idea how to remove a perl module and besides the make test says everything is fine. make install also give no errors. however Openprotect install still stops at the same point with the same error. (see below) Could someone tell me how to check my Perl modules installation (which would be a useful thing to learn) and maybe give me some guidance on if I have to pull 2.109 or if perhaps I am doing something else wrong. I tried to find info on perl module removal but I get a bit lost. Many thanks for your time. Charles Overy LGM Open protect install script clipping is below------------ Successfully installed module ExtUtils-MakeMaker-6.05 Installing Net-CIDR-0.09... Checking installation status of Perl module Net::CIDR version 0.09... Module Net::CIDR 0.09 or greater is already installed.Actual version is 0.09. Successfully installed module Net-CIDR-0.09 Installing IO-stringy-2.108... Checking installation status of Perl module IO::stringy version 2.108... Module IO::stringy-2.108 not installed. ./perlmod.sh: line 36: cd: perl/IO-stringy-2.108: No such file or directory make: *** No rule to make target `clean'. Stop. Can't open perl script "Makefile.PL": No such file or directory Failed to install module IO-stringy-2.108
