Did you compile the CTC modules using OpenDX? because if you used the commercial DX modules, they wouldn't work with OpenDX.
-ba Victor Omark wrote: > > Hi, > > I'm trying to run an outboard module using OpenDX. I have tried everything > what the > IBM manual says about outboard modules and variables. I already set the > variables > DXMODULES, DXDATA, and DXHOST to the right parameter but this module > (ImportStructure) doesn't recognize the data file. This is what I got; > > Starting DX executive > Memory cache will use 24 MB (2 for small items, 22 for large) > port - 1900 > server: accepted connection from client > 0: worker here [14555] > 0: Starting /home/mendezfe/opendx/CMSP/bin/ImportStructure on localhost; will > wait > up to 60 seconds for connections. > 0: error at end of ImportStruc > Begin Execution > ERROR: ImportStructure: Bad parameter: cannot open file > > Writing the whole data file fullpath didn't work either and in my mdf file I > included the full ppath of this module. > I'm using an alpha, Compaq with UNIX oper. system. > Any suggestions, > Thanks in advance, > > V.Omark -- Dr. A. Ballard Andrews Schlumberger Doll Research Old Quarry Road Ridgefield, CT 06877 tel: 203-431-5522 fax: 5521
