I used a makefile that comes with these CTC modules. Do you know how can I compile these module in a different way so they can work? Do you know where can I learn more about how to compile outboard modules using DX?
Thanks, V.Omark ballard andrews wrote: > Did you compile the CTC modules using OpenDX? > because if you used the commercial DX > modules, they wouldn't work with OpenDX. > > -ba > > Victor Omark wrote: > > > > Hi, > > > > I'm trying to run an outboard module using OpenDX. I have tried everything > > what the > > IBM manual says about outboard modules and variables. I already set the > > variables > > DXMODULES, DXDATA, and DXHOST to the right parameter but this module > > (ImportStructure) doesn't recognize the data file. This is what I got; > > > > Starting DX executive > > Memory cache will use 24 MB (2 for small items, 22 for large) > > port - 1900 > > server: accepted connection from client > > 0: worker here [14555] > > 0: Starting /home/mendezfe/opendx/CMSP/bin/ImportStructure on localhost; > > will wait > > up to 60 seconds for connections. > > 0: error at end of ImportStruc > > Begin Execution > > ERROR: ImportStructure: Bad parameter: cannot open file > > > > Writing the whole data file fullpath didn't work either and in my mdf file I > > included the full ppath of this module. > > I'm using an alpha, Compaq with UNIX oper. system. > > Any suggestions, > > Thanks in advance, > > > > V.Omark > > -- > Dr. A. Ballard Andrews > Schlumberger Doll Research > Old Quarry Road > Ridgefield, CT 06877 > tel: 203-431-5522 fax: 5521
