I have done this as a macro using looping controls. It is not the
most efficient way to do it, but it does work. It would be better if
the Tube module had someone enchance it to provide this functionality
since often people want to do this. Sorry, but it does not
immediately support this at this time.
David
> You don't want to hook it up to the Tube's diameter input. You want
to hook the Import to the line input of Tube and set the diameter to
a number to produce the correct size you want.
Yes, I have done this before - but this yields the same diameter for all
the Tubes, right? My idea is that the diameter varies depending on a diameter
that is included in the dx file (e.g. the data section of the Polylines.dx
example) I'm going to import a water network from GIS data.
Steffen
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
--
.............................................................................
David L. Thompson The University of Montana
mailto:[EMAIL PROTECTED] Computer Science Department
http://www.cs.umt.edu/u/dthompsn Missoula, MT 59812
Work Phone : (406)257-8530
