Dnia środa, 26 stycznia 2011 o 10:40:25 Ulf Samuelsson napisał(a): > I have some calibration problem with my private branch > (ulf/linux-2.6.30-2011-01-??) when building the at91sam9m10ekes board. > > I am running /usr/bin/run-calibrate.sh, > but regardless of how I click, during calibration, > a tap afterwards always results in detection 3 mm above the tap. > > There is a "pointercal" file generated. > It appears to me that this is ignored... > I can tap 1 cm above or below during calibration, > and still the detected tap is 3 mm above the actual tap. > Anything else to think about? > I enclose /etc/X11/xorg.conf and /etc/ts.conf.
You are using full X11 with evdev driver so tslib is not used at all. You have to use xinput-calibrator. Regards, -- JID: [email protected] Website: http://marcin.juszkiewicz.com.pl/ LinkedIn: http://www.linkedin.com/in/marcinjuszkiewicz _______________________________________________ Openembedded-devel mailing list [email protected] http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/openembedded-devel
