On Wed, Jan 26, 2011 at 06:36:12PM +0100, Ulf Samuelsson wrote: > 2011-01-26 14:01, Marcin Juszkiewicz skrev: > > Dnia środa, 26 stycznia 2011 o 10:40:25 Ulf Samuelsson napisał(a): > >> I have some calibration problem with my private branch > >> (ulf/linux-2.6.30-2011-01-??) when building the at91sam9m10ekes board. > >> > >> I am running /usr/bin/run-calibrate.sh, > >> but regardless of how I click, during calibration, > >> a tap afterwards always results in detection 3 mm above the tap. > >> > >> There is a "pointercal" file generated. > >> It appears to me that this is ignored... > >> I can tap 1 cm above or below during calibration, > >> and still the detected tap is 3 mm above the actual tap. > > > >> Anything else to think about? > >> I enclose /etc/X11/xorg.conf and /etc/ts.conf. > > You are using full X11 with evdev driver so tslib is not used at all. You > > have > > to use xinput-calibrator. > > > > Regards, > > Any clue to get xinput-calibrate to run at first boot?
provide recipes/xinput-calibrator/pointercal-xinput data for your device and use recipes/xserver-common/files/89xTs_Calibrate.xinput_calibrator.patch like SHR does intentionaly it prefers provideded data, because users too often messed initial calibration on first boot and then didn't know how to reset it and rerun xinpu-calibration successfully... -- Martin 'JaMa' Jansa jabber: [email protected]
pgpJdM8WpjGhb.pgp
Description: PGP signature
_______________________________________________ Openembedded-devel mailing list [email protected] http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/openembedded-devel
