Hi Dan,
I change the host parameter as you suggested and it works !!!
Back to first question about max flow entries,
I ran the test below and used the Web UI to see the number of flow entries :
+ FillTableExact : 1920 (flow entries)
+ FillTableWc : 1919 (flow entries)
Here is the HW information about our Pronto switch 3290
CPU: 8541, Version: 1.1, (0x80720011)
Core: E500, Version: 2.0, (0x80200020)
Clock Configuration:
CPU: 825 MHz, CCB: 330 MHz,
DDR: 165 MHz, LBC: 41 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
I2C: ready
DRAM: Initializing
DDR: 512 MB
FLASH: 32 MB
L2 cache 256KB: enabled
Set ethaddr MAC address = e8:9a:8f:fb:c3:fc
Set eth1addr MAC address = e8:9a:8f:fb:c3:fd
In: serial
Out: serial
Err: serial
Net: TSEC0, TSEC1
IDE: Bus 0: OK
Device 0: Model: 2GB CompactFlash Card Firm: CF B612D Ser#:
C321102416A10v4B618j
Type: Hard Disk
Capacity: 1953.9 MB = 1.9 GB (4001760 x 512)
Could you compare with your switch ? Thanks
Nam
On 05/03/2012 05:57 PM, Dan Talayco at gmail wrote:
Oops, wait. I misread the subject.
If you are trying to connect to a 3290, you can't specify
--host=127.0.0.1 (that would be trying to connect to a vswitch running
on the local host.
Assuming you're talking to the 3290 over an interface with the IP
address 192.168.1.1(for example) you would use that:
sudo ./oft --host=192.168.1.1 --port=6634 --verbose --test-spec=Echo
--platform=remote
The remote platform doesn't really matter if you're not using data
plane tests. Again, this assumes your 3290 is trying to talk to a
controller at 192.168.1.1 at port 6634. Note that no other controller
should be running on the same host.
-Dan
_______________________________________________
openflow-discuss mailing list
openflow-discuss@lists.stanford.edu
https://mailman.stanford.edu/mailman/listinfo/openflow-discuss
