[EMAIL PROTECTED] wrote on 09/25/2007 03:19:42
PM:
> All,
>
> Does the OpenHPI infrastructure provide a way for a plug-in to
> communicate add/remove of FRUs (Memory Modules, power supplies, and fans
> for example) that are non-hotswap units? FRUs could be removed or added
> while the target system is in a powered down state. I don't see any
> event that can be used for this case. I see hotswap state changes which
> are not applicable for this scenario.
>
The question should be whether HPI provides a way to communicate
"coldplug" (?) events. HPI doesn't explicitly, but you can still use
hotswap events and the simplified hotswap model (e.g. Active<->Not
Present) to model the same. See page 185 of HPI spec.
--Renier-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Openhpi-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openhpi-devel
