Hello! Quoting r. Grant Grundler ([EMAIL PROTECTED]) "[openib-general] HP ZX1 and HP IB cards...": > So the adventure continues on a different box (rx4640). > (I'll go back to the rx2600 and reflash/reboot the box). > > With tvflash, I was able to upload the hca-cougar image I mentioned > before successfully...at least that's what tvflash asserted. > > If you want me to try a different firmware, we should do that off-list. > > Running 2.6.10-rc2 kernel ended up with the following output: > iowa:~# modprobe ib_mthca > ib_mthca: Mellanox InfiniBand HCA driver v0.06-pre (November 8, 2004) > ib_mthca: Initializing Mellanox Technology MT23108 InfiniHost (0000:41:00.0) > GSI 38 (level, low) -> CPU 1 (0x0100) vector 66 > ACPI: PCI interrupt 0000:41:00.0[A] -> GSI 38 (level, low) -> IRQ 66 > ib_mthca 0000:41:00.0: SYS_EN DDR error: syn=0, sock=0, sladdr=0, SPD > source=DIMM > ib_mthca 0000:41:00.0: SYS_EN returned status 0x07, aborting. > ib_mthca: probe of 0000:41:00.0 failed with error -22 > iowa:~# tvflash -i > open_hca(0) > flash_chip_reset() > flash_check_failsafe() > > Error. String Tag not present (found tag 43 instead) > HCA #0: Found MT23108, Cougar, revision A1 > Primary image is valid, unknown source (sig 0x0/0x0) > Secondary image is valid, unknown source (sig 0x0/0x0) > > > Error. String Tag not present (found tag 43 instead) > close_hca() > Vital Product Dataiowa:~# > > tvflash isn't able to ID the new downloaded firmware. > Seems like a bug but I don't have specs to see what it is. > > iowa:~# lspci -vs 41:0.0 > 0000:41:00.0 InfiniBand: Mellanox Technology MT23108 InfiniHost (rev a1) > Subsystem: Mellanox Technology MT23108 InfiniHost > Flags: 66MHz, medium devsel, IRQ 66 > Memory at 00000000a0800000 (64-bit, non-prefetchable) [size=1M] > Memory at 00000000a0000000 (64-bit, prefetchable) [size=8M] > Memory at <unassigned> (64-bit, prefetchable) > Capabilities: [40] #11 [001f] > Capabilities: [50] Vital Product Data > Capabilities: [60] Message Signalled Interrupts: 64bit+ Queue=0/5 > Enable- > Capabilities: [70] PCI-X non-bridge device. > > Oh...I think I see the problem. > System Firmware is having problems with this card. > I need to update firmware on this box anyway and will report back. > > thanks, > grant
If you think its a flash issue, try flashing with flint (mstflint under openib tree works without kernel modules). this is what we always use in mellanox for cougars. MST _______________________________________________ openib-general mailing list [EMAIL PROTECTED] http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
