On Fri, 2005-09-02 at 08:38, Sean Hubbell wrote: > I looked at the arp table and the ib0 device is not listed. The state is > marked as ACTIVE for port 1. Does this mean that a connection to opensm > has been established and not necessarily that this interface has been > enabled for use (meaning the connection to opensm with over eth0 instead > of ib0)?
If there are no ARP entries on an ib<n> interface, I don't think it would show up there. If you ping an explicit address on that ib<n> subnet, you would see something like: ? (192.168.0.2) at <incomplete> on ib0 I presume you've modprobe'd ib_ipoib and ifconfig'd ib<n> to get it up and running (ifconfig -a shows ib<n> in an UP state). -- Hal _______________________________________________ openib-general mailing list openib-general@openib.org http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
