On 3/4/06, Suresh Shelvapille <[EMAIL PROTECTED]> wrote: > > Folks: > > Two commercial switches are connected to each other via two of our devices > (which act like switches). One HCA is connected to each of the commercial > switches. Upon power up, everything is normal and when I ping one HCA from > the other everything is fine. > When everything is operational, if I move one of the HCAs from one switch > port to another on the same switch, then the pings start to take an enormous > amount of time.... > > When a port move happens, is there some SMP sent from the SM(the SM is on > the commercial switch) which we may not be handling in our device, which > could be causing this delay?
What happens if you take your device out of the equation - that is, connect the two switches together? This would isolate the cause of the problem. It may not even be your device at all. - Fab _______________________________________________ openib-general mailing list [email protected] http://openib.org/mailman/listinfo/openib-general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
