Kevin or David,
Ideas on how to get Prasant past this issue? Apparently he has his
pango libs installed in a non-standard location and needs to use
PKG_CONFIG_PATH so they can be found.
Thanks,
Lisa
-------- Original Message --------
Subject: Re: openjfx-8u20-b23: Stuck in monocle build for armv7hf
Date: Thu, 31 Jul 2014 11:37:08 +0530
From: Prasant J <pj0...@gmail.com>
To: Lisa Selle <lisa.se...@oracle.com>
CC: openjfx-dev@openjdk.java.net Mailing <openjfx-dev@openjdk.java.net>
On Thu, Jul 31, 2014 at 10:10 AM, Prasant J <pj0...@gmail.com> wrote:
On Wed, Jul 30, 2014 at 11:16 PM, Lisa Selle <lisa.se...@oracle.com> wrote:
How did you install your arm toolchain?
I'm using yocto (poky distribution) for my iMX6. I can build my own
SDK (toolchain). I'm using that.
I may have made some mistake is setting up the toolchain (I will look
into that one again).
I have now corrected the toolchian setup!
https://wiki.openjdk.java.net/display/OpenJFX/Cross+Building+for+Arm+Hard+Float
If it's installed according to these instructions pkg-config should get
picked up from the correct place and there should be no need to set any
environment variables.
Is there a way to set environment variables?
Still stuck at the same point.
In my linux shell I executed the following commands:
./pkg-config --cflags pangoft2 [cannot find package pangoft2]
PKG_CONFIG_PATH=<path> ./pkg-config --cflags pangoft2 [finds the
package and lists the cflags]
So, is there any way to pass the environment variable PKG_CONFIG_PATH
before executing 'commandLine' ?
Regards, Pj
