Hi, > Daehyung Jo schrieb: > > I have compiled successfully with "ccmake ." in a clean state :) > > I ran with the same command "./obexpushd -nda ./test.txt" but this time > N95 > > does not show a passcode pop up window and obexpushd generated following > > messages. > > Remove the .security_init entry from bluetooth_funcs struct in > src/net/btobex.c and recompile. obexpushd-0.8 only allows either > transport level security or obex authentication. With current SVN, you > can do both with an additional parameter -A. > > Obex authentication is untested in all versions and thus highly > experimental. I would be very happy if you are able to debug the code on > problems. I do not have any clients available that can use this. > > HS >
I tried as your instructions. The result is the same with the case of obexpushd 0.6, which means nokia N95 prompts a passcode window and tries to reconnect with the passcode but the procedure repeats forever, this time without seg. fault :) I will download newest SVN source codes and test again but think I should dig into the code with great effort to make these things work fine. BTW, if your obex auth codes are included in the next version openobex, are you gonna use the GPL for those files or change the license as LGPL? Thanks a lot and good luck! Best Regards, Jo ------------------------------------------------------------------------------ Check out the new SourceForge.net Marketplace. It is the best place to buy or sell services for just about anything Open Source. http://p.sf.net/sfu/Xq1LFB _______________________________________________ Openobex-users mailing list Openobex-users@lists.sourceforge.net http://lists.sourceforge.net/lists/listinfo/openobex-users
