Freddie Chopin <freddie_chopin@...> writes: > > W dniu 2012-03-08 18:54, Mathias K. pisze: > > i see some problems with the reset button (hardware reset) and openocd: > > > > > > 1. connect the eval board > > 2. connect openocd without a cpu init script > > 3. press hardware reset button > > 4. board resets and restart > > > > 5. telnet to openocd > > 6. do a reset command > > 7. board resets and restart > > > > 8. press hardware reset button > > 9. board resets but stoped execution > > > > Whats wrong? Is this a issue with the stlink v2 or something related to openocd? > > I think that's because reset output of the debugger is in push-pull mode. > > 4\/3!! > > ------------------------------------------------------------------------------ > Virtualization & Cloud Management Using Capacity Planning > Cloud computing makes use of virtualization - but cloud computing > also focuses on allowing computing to be delivered as a service. > http://www.accelacomm.com/jaw/sfnl/114/51521223/ > No. After hw reset openosd tell follow: "target state: halted target halted due to debug-request, current mode: Thread xPSR: 0x01000000 pc: 0x08001814 msp: 0x20005000"
And I can't find command to disable it... Any idea? ------------------------------------------------------------------------------ Virtualization & Cloud Management Using Capacity Planning Cloud computing makes use of virtualization - but cloud computing also focuses on allowing computing to be delivered as a service. http://www.accelacomm.com/jaw/sfnl/114/51521223/ _______________________________________________ OpenOCD-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/openocd-devel
