I don't know if we need to change something. I have seen the following things
and that's the main
reason why i ask about the reset button problem:
Openocd is always running on my setup and i reflash the device with a simple
script that use nc to
pipe some commands to the telnet port of openocd. Sometimes, i think it is
after a hard fault, i can
flash and "soft" reset the device but nothing happens. The device wont start. I
need to press the
reset button, then i see the "magic" stop, and after another reflash ("soft"
reset included) the
device is running. Maybe there is something with the "soft" reset and the
periphery state, maybe
not. I have not seen this problem with other stm32 devices and a low level jtag
adapter.
Regards,
Mathias
On 14.03.2012 19:32, md5sum wrote:
> Freddie Chopin <freddie_chopin@...> writes:
>
>
>>
>> Maybe I don't understand you? Do you want your target to run after you
>> push the reset button while OpenOCD is connected?
>>
>
> Sorry.
> Yes, target to run after hw reset, and stop expecting instant debuging
> process.
> openoŃd enabled debug at startup and does not turn off after finished.
>
> Regards.
>
>
> ------------------------------------------------------------------------------
> Virtualization & Cloud Management Using Capacity Planning
> Cloud computing makes use of virtualization - but cloud computing
> also focuses on allowing computing to be delivered as a service.
> http://www.accelacomm.com/jaw/sfnl/114/51521223/
> _______________________________________________
> OpenOCD-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/openocd-devel
------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
