Added the watchdog code in a new patch: http://openocd.zylin.com/2986
Tested on my K22, and works like a charm. I just realized that my push updated your patch sets. That was not intentional! Or was it supposed to do that since my patch is based on your patches, and I rebased them on the current master? Hope I didn't cause any trouble. I am just not used to working with gerrit... - Thomas On Wed, Sep 30, 2015 at 1:06 AM, Tomas Vanek <[email protected]> wrote: > On 30.09.2015 7:38, Tomas Vanek wrote: > > VLPR is not active until you set LPBOOT option FOPT register (0x40d) > Patch should cover much more devices than K22. > > Sorry, Kx MCUs always use normal run mode after reset - so using reset > init before programming is sufficient. > VLPR mode after reset can be configured by LPBOOT option on some KL > devices (e.g. KL17). > > Tom >
------------------------------------------------------------------------------
_______________________________________________ OpenOCD-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/openocd-devel
