The size of working area *must* not have any influence except speed (as long as
the memory is present and operating properly), otherwise there is probably a
bug lurking around: The L073 hasn't got ECC for RAM nor watchdogs, which could
cause obvious trouble. Hence it might be useful to dig into this further ...
BTW: Does this problem occur on an 'empty' device, or when there's already
something programmed in the flash?
---
** [tickets:#231] STM32L07x dual bank fails flashing**
**Status:** new
**Milestone:** 0.9.0
**Created:** Sun Mar 31, 2019 09:57 AM UTC by Martin Jäger
**Last Updated:** Thu Apr 04, 2019 09:12 AM UTC
**Owner:** nobody
I'm not able to flash my STM32L073 with the settings stated in
https://sourceforge.net/p/openocd/code/ci/master/tree/tcl/board/st_nucleo_l073rz.cfg
If I change the WORKAREASIZE to 0x1000, everything works fine.
Do you agree to change the setting?
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
