Oh, yes, overlooked the watchdogs at the very end of the features list ...
I didn't mean brand-new. Just do a mass-erase and verify that option bytes are
at factory settings (in particular hardware/software watchdog), power-cycle
board and stlink, and restart OpenOCD. This should be sufficient to see whether
the problem might be related to firmware or option settings.
---
** [tickets:#231] STM32L07x dual bank fails flashing**
**Status:** new
**Milestone:** 0.9.0
**Created:** Sun Mar 31, 2019 09:57 AM UTC by Martin Jäger
**Last Updated:** Fri Apr 05, 2019 11:31 AM UTC
**Owner:** nobody
I'm not able to flash my STM32L073 with the settings stated in
https://sourceforge.net/p/openocd/code/ci/master/tree/tcl/board/st_nucleo_l073rz.cfg
If I change the WORKAREASIZE to 0x1000, everything works fine.
Do you agree to change the setting?
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
