On Thu, 2009-04-23 at 17:41 +0200, R.Doss wrote: > Edgar Grimberg schrieb: > > Hi, > > > > > > > Anyone got experience with bringing up the AT91SAM9260 based boards > > > and know what the min init is? Can I use the working u-boot to probe > > > these registers and figure out the settings that way? The board came > > > with EasyICE (which is a parallel wiggler) and a software tool to > > > reflash the NOR flash, but I've tried it on two different computers > > > and can't get it to work. I wish I had the source to this utility > > > because I'm sure it holds the key to the proper init sequence of the > > > board. > > > > > > > Thy looking into this script, maybe you can find the proper settings > > > > /src/target/board/unknown-board-atmel-at91sam9260.cfg > > > > Regards, > > > > Edgar > > > > > The script is not good enought. It works not perfect. > I had the same trouble. > > https://lists.berlios.de/pipermail/openocd-development/2009-April/005271.html > > Try it with the attached configfile.
After this is sorted out, could I talk one of you to send a patch that fixes the problems with that configuration? There's not much sense having target scripts in the tree that do not work; even if this is a corner case that will be commented out in the example file, I would rather see it make its way into the SVN tree. I will put this on The List until I see this topic resolved. Cheers, Zach _______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
