I've U-Boot running on the board. I attach the OpenOCD, the target is validated fine and continues running. I connect via telnet and issue a "reset halt" - the target fails to halt, and communication is broken afterwards. It's a SAM9L9260 board from Olimex.
Regards, Dominic -------- Original-Nachricht -------- > Datum: Tue, 7 Jul 2009 08:58:19 +0200 > Von: "Øyvind Harboe" <[email protected]> > An: Dominic <[email protected]> > CC: [email protected] > Betreff: Re: [Openocd-development] arm926ejs & i.MX27 testers out there > On Tue, Jul 7, 2009 at 8:57 AM, Dominic<[email protected]> wrote: > > On Monday 06 July 2009 23:31:47 Øyvind Harboe wrote: > >> Hmmm.... > >> > >> 838 - 729 covers a *lot* of changes.... but nothing > >> that stands out as a suspect. > >> > >> If you have time to narrow this down further then that would be > >> *great*. > >> > >> 788 has the startup tcl script embedded. That could be > >> the problem you are seing in 783. > > > > You were right, 788 worked again - but not with "reset halt" debugging > > though. > > Which means the bug is between 788 - 729... > > If you give me the precise test procedure you use, I've got > two arm926ejs targets I can test on here. > > -- > Øyvind Harboe > Embedded software and hardware consulting services > http://www.zylin.com -- -- Dominic Rath <[email protected]> _______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
