I tried to use OpenOCD with the very basic test setup for my board (thanks to Michael Fischer). Inside the SAM7S256Test folder you will find a file openocd.cfg. This contains all the "settings" to connect to my target(i.e. Olimex AT91SAM7s256 Board with ARM-USB-TINY(olimex)).
Yagarto toolchain is working fine and I was able to use "make clean" and "make all" commands to clean and build the project. But the problem comes when I give "openocd" at cmd line. Michael informed me that on this I should get connected to the Target through OpenOCD. But I get an error message in a new window saying "openocd.exe has stopped working" and the usual message whether to close, debug or look for a online solution. Am I missing something here. i have attached the zip provided by Michael with the mail. Also the inf files I had modified which were sent sometime back and were found to be Ok. Regards Rohit On Wed, Aug 26, 2009 at 2:36 AM, Freddie Chopin <[email protected]>wrote: > Rohit Chandel pisze: > > Is there any quick test to find out that openocd is installed correctly? > > use it. > > 4\/3!! > _______________________________________________ > Openocd-development mailing list > [email protected] > https://lists.berlios.de/mailman/listinfo/openocd-development >
_______________________________________________ Openocd-development mailing list [email protected] https://lists.berlios.de/mailman/listinfo/openocd-development
