Hi,
the new Marvell PXA270M processor has a new TAPID: 0x89265013.
Attached you will find a patch for target/pxa270.cfg that will handle this.
I have also attached a board/colibri.cfg file to support the Colibri
PXA270 module by Toradex.
Hope you can use it!
Best regards,
Áron Takács
# Toradex Colibri PXA270
source [find target/pxa270.cfg]
reset_config trst_and_srst srst_push_pull
adapter_nsrst_assert_width 40
# CS0 -- one bank of CFI flash, 32 MBytes
# the bank is 32-bits wide, two 16-bit chips in parallel
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME cfi 0x00000000 0x02000000 2 4 $_TARGETNAME
init
reset halt
--- src/openocd/tcl/target/pxa270.cfg
+++ openocd_work/target/pxa270.cfg
@@ -27,6 +27,12 @@
set _CPUTAPID2 0x79265013
}
+if { [info exists CPUTAPID3 ] } {
+ set _CPUTAPID2 $CPUTAPID3
+} else {
+ # set useful default
+ set _CPUTAPID3 0x89265013
+}
# set adapter_nsrst_delay to the delay introduced by your reset circuit
# the rest of the needed delays are built into the openocd program
@@ -36,7 +42,7 @@
jtag_ntrst_delay 250
set _TARGETNAME $_CHIPNAME.cpu
-jtag newtap $_CHIPNAME cpu -irlen 7 -ircapture 0x1 -irmask 0x7f -expected-id $_CPUTAPID -expected-id $_CPUTAPID2
+jtag newtap $_CHIPNAME cpu -irlen 7 -ircapture 0x1 -irmask 0x7f -expected-id $_CPUTAPID -expected-id $_CPUTAPID2 -expected-id $_CPUTAPID3
target create $_TARGETNAME xscale -endian $_ENDIAN -chain-position $_TARGETNAME -variant pxa27x
# maps to PXA internal RAM. If you are using a PXA255
_______________________________________________
Openocd-development mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/openocd-development
