2012/2/22 Julius Baxter <[email protected]>: > On Mon, Feb 6, 2012 at 4:01 PM, Olof Kindgren <[email protected]> wrote: >> Allow setting the boot address as a parameter. If the parameter is not >> set, it will fallback to using `OR1200_BOOT_ADR as previously >> This makes it easier to set boot address to 0x100 in a testbench to >> run with a preloaded ram while being able to use i.e. 0xF0000100 to >> use the boot rom when building for a real FPGA. >> Changes are for upstream version and orpsocv2 version of or1200 > > I like this and think it makes sense. > > Julius
I will push a slightly different version later today. The only change is that I move the icpu_adr_boot up a few lines so that it is declared before it is used -- Olof Kindgren ______________________________________________ ORSoC Website: www.orsoc.se Email: [email protected] ______________________________________________ FPGA, ASIC, DSP - embedded SoC design _______________________________________________ OpenRISC mailing list [email protected] http://lists.openrisc.net/listinfo/openrisc
