Yes, all the payload nodes were running while expanding the cluster size from 2 payload nodes to 3. Even I tried stopping the opensafd service in both payload1 and paylod2.
The content of the nodes.cfg are: Existing Nodes: SC SC-1 sc-active SC SC-2 sc-standby PL PL-1 payload1 PL PL-2 payload2 New Node Configuration added: PL PL-3 payload3 Where, payload1, payload2 and payload3 are the host names for all the payload nodes and sc-active, sc-standby are the host names of the controller nodes. Thanks, Greg On Thu, Dec 5, 2013 at 9:28 PM, Nivrutti Kale <[email protected]> wrote: > Hi Greg, > > Does all your existing nodes running when you are trying to expand the > cluster? > Also share the contents of nodes.cfg mentioning current and new nodes > entry. > > Thanks & Regards, > Nivrutti > > > On Fri, Dec 6, 2013 at 4:04 AM, Greg Hurlman <[email protected]>wrote: > >> Hi, >> >> >> I followed the above mentioned steps to add dynamically a new payload >> node while the existing payload nodes were running. And when I ran the >> modify script after adding the entry in nodes.cfg, the below error I am >> getting. Anybody faced similar issue before?? >> >> *[root@sc-active immxml]# ./immxml-modify-config* >> *error: When expanding the cluster all existing nodes must be started >> (saAmfNodeOperState=1). Exiting!* >> >> It did not reboot the payload nodes, neither it got added to the cluster. >> Anything obvious I am missing here? >> >> Thanks, >> Greg >> >> >> On Wed, Dec 4, 2013 at 9:34 PM, Nivrutti Kale <[email protected]> wrote: >> >>> Hi Greg, >>> >>> You can use the ./immxml-modify-config for adding new payload nodes to >>> the running cluster without >>> stopping the running controllers or payload nodes. >>> >>> Steps to run: >>> >>> 1. Add entries for newly added payload nodes in nodes.cfg >>> 2. Run ./immxml-modify-config >>> >>> Hope that helps. >>> >>> Thanks & Regards, >>> Nivrutti >>> >>> >>> >>> >>> On Thu, Dec 5, 2013 at 6:37 AM, Greg Hurlman <[email protected]>wrote: >>> >>>> Hi, >>>> >>>> I have a running cluster with 2 payload nodes created by using >>>> >>>> immxml-clustersize -s 2 -p 2 >>>> >>>> Can I dynamically add a new payload node to this running cluster without >>>> stopping the running controllers or payload nodes? or What is the best >>>> way >>>> to do so? Are there any workarounds if not possible? >>>> >>>> Appreciate for any help. >>>> >>>> Thanks >>>> Greg >>>> >>>> ------------------------------------------------------------------------------ >>>> Sponsored by Intel(R) XDK >>>> Develop, test and display web and hybrid apps with a single code base. >>>> Download it for free now! >>>> >>>> http://pubads.g.doubleclick.net/gampad/clk?id=111408631&iu=/4140/ostg.clktrk >>>> _______________________________________________ >>>> Opensaf-users mailing list >>>> [email protected] >>>> https://lists.sourceforge.net/lists/listinfo/opensaf-users >>>> >>> >>> >> > ------------------------------------------------------------------------------ Sponsored by Intel(R) XDK Develop, test and display web and hybrid apps with a single code base. Download it for free now! http://pubads.g.doubleclick.net/gampad/clk?id=111408631&iu=/4140/ostg.clktrk _______________________________________________ Opensaf-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/opensaf-users
