Hi, # dladm show-link # dladm show-ether # dladm show-phys # dladm show-linkprop <interface name> or without a name it will show you properties for all interfaces
And yes it's often necessary to change properties, ie. auto-negotiation and mtu/jumbo frames. Cheers, - Lasse On 13/02/2010, at 18.02, Matthias Pfützner wrote: > first try > > ifconfig -a > > Then you might need to run > > ndd > > on the individual interfaces... > > So, why the need to get/set these "boring" details? The drivers are normally > clever enough to figure these settings by themselves... I never had the need > to set any of those things... > > Matthias > > -----Ursprüngliche Nachricht----- >> Von: Jeff Freeman <[email protected]> >> Gesendet: 13.2.'10, 17:48 >> Hi there - I'm used to using lanadmin and being new to this operating system >> - can any one give me a command or script that will tell me how each nic is >> setup *(i.e. full/duplex/speed) etc. Thanks a lot Jeff > _______________________________________________ > opensolaris-discuss mailing list > [email protected] _______________________________________________ opensolaris-discuss mailing list [email protected]
