> > During install in stub domain F8,F9,CentOS 5.X
> load
> > "ata_piix" driver exactly as on old S478 Intel
> > Boards.
> > Compare with CR 6650131 i see same errors when
> > loading SNV_79,SNV_98 in stub domain :
> >
> ******************************************************
>
> > *************************************
> > Configuring /dev
> > ata_command: BSY too long!DRDY 0x1 CMD 0xe0 F 0x0
> N
> > 0x0 S 0x0 H 0x0 CL 0x0 CH 0x0
> >
> ******************************************************
>
> > ************************************
> > Dell 4550 mentined in CR 6650131 has board
> described
> > at:-
> >
> http://www.ascendtech.us/itemdesc.asp?ic=MB4DELJ0592
> >
> > * Support for an Intel? Pentium? 4 processor in a
> > mPGA478 socket with a 400/533 MHz system bus
> > * Support for an Intel? Celeron? processor in a
> > mPGA478 socket with a 400 MHz system bus
> > Intel? 845PE Chipset
> > Two Parallel ATA IDE interfaces with UDMA 33,
> > ATA-66/100 support
> >
> > My guess would be , that current Nevada Builds
> won't
> > install on Intel S478 boards with mentioned ATA
> > specs, no matter of PC been built on the board
> with
> > Intel S478. (years 2000-2002).
> > However , Solaris 10 will. Unfortunately, i don't
> > have any Intel S478 board to test.
> ***************************************
> Failure reproduce CR 6650131
> ***************************************
> I've made an attempt to reprodule CR 6650131 on the
> box assembled with:-
> CPU P4 2.6 GHZ
> 1 GB RAM
> Board :
> ECS (Elitegroup) 845PE-A
> 2 channel UltraDMA/100/66/33 Bus Master IDE (with
> support for up to 4 ATAPI-devices)
> 80 GB IDE Seagate Barracuda.
>
> SNV_94 loaded with no problems and entered
> configuration phase.
**************************************************
CR 6650131 reproduced on mentioned hardware
**************************************************
It's a kind of difficult to explain, message
"ata-command select failed" began come up
on regular basis some hours later with another
similar IDE drive. I had to replace IDE drive to
be able perform complete test and proceed to
deployment phase.Entering deployment phase
i get message "No hard drive found".
--
This message posted from opensolaris.org
