Hi, I tried again the Cubox-i Tumbleweed image (openSUSE-Tumbleweed-ARM-JeOS-cuboxi.armv7l-2016.05.05-Build1.4.raw.xz ) but it's broken again. This time, I get:
=> run bootcmd switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found U-Boot script /boot.scr 2750 bytes read in 34 ms (78.1 KiB/s) ## Executing script at 12000000 switch to partitions #0, OK mmc0 is current device 7420680 bytes read in 519 ms (13.6 MiB/s) 79608549 bytes read in 4776 ms (15.9 MiB/s) 38156 bytes read in 306 ms (121.1 KiB/s) Kernel image @ 0x10800100 [ 0x000000 - 0x713b08 ] ## Loading init Ramdisk from Legacy Image at 14800100 ... Image Name: Initrd Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 79608485 Bytes = 75.9 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 14700100 Booting using the fdt blob at 0x14700100 Using Device Tree in place at 14700100, end 1470c60b Starting kernel ... [ 0.225135] imx-gpc 20dc000.gpc: failed to get pu regulator: -517 [ 6.376159] imx-gpc 20dc000.gpc: failed to get pu regulator: -517 [ 6.383309] sr_init: platform driver register failed for SR [ 6.403448] Unable to find PPMU node setterm: cannot (un)set powersave mode: Inappropriate ioctl for device [ 11.269077] systemd-udevd[247]: could not dup netlink fd: File exists [ 11.275601] systemd-udevd[247]: could not listen on fds: File exists [ 169.866174] reboot: Restarting system Any hints how to fix it? Best, Tom -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
