On Freitag, 30. September 2016 13:20:54 CEST Freek de Kruijf wrote: > Op vrijdag 30 september 2016 10:54:04 schreef Freek de Kruijf: > > Just tried the image for the Raspberry Pi 3 > > openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3_aarch64.aarch64-2016.09.27- > > Build6.1.raw.xz and I have a working system. > > > > The only problem I had was, when I had a USB storage device connected, the > > system did not continue in the boot process, or I was too inpatient. I > > disconnected that device and started the boot process again and now I have > > a working system. > > I had some trouble to configure my system, which I want to have an external > USB disk. After the initial boot I connected that device executed the yast > partitioner and added the device in /etc/fstab. However a reboot did not > work anymore, not even with the USB disk disconnected. In that case GRUB > did not complete the boot process. > > So I started all over again. I made small steps and now I have a system that > only boots with a disconnected USB disk, but it has an entry in /etc/fstab > for that device, so when I connect the USB disk after the boot, the system > mounts the device and I have the system I want. The remaining problem so > far, is that it does not survive a power failure.
Do you have a USB/Serial converter you can connect to the Pi? There may be some useful output during the boot process. Kind regards, Stefan -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
