As far as I remember there is a ticket in the bugzilla according generic armv6 faluire.
07.11.2019 13:20, Guillaume Gardet пишет: > Hi Matthias, > >> -----Original Message----- >> From: Matthias Brugger <[email protected]> >> Sent: 07 November 2019 10:33 >> To: Mailinglist openSUSE ARM <[email protected]> >> Cc: [email protected]; Michael Ströder <[email protected]>; >> Freek de Kruijf <[email protected]> >> Subject: [opensuse-arm] tumbleweed on RPi Zero W >> >> Hi all, >> >> Yesterday I tried openSUSE Tumbleweed image on my RPi Zero W (v1.1) with >> JeOS image. I was able to boot into grub but didn't see any output from the >> kernel on the serial console. I saw that console was set to ttyAMA0, I tried >> also >> with >> ttyS0 and ttyS1, as well as with earlycon as described in [1]. But no luck. >> >> Was anyone able to boot the newest [2] RPi tumbleweed image just using the >> serial console, or do I need a monitor on the firstboot? > > No, you should be able to boot it with serial only. > > I tried this image on a RPi1, with serial and HDMI connected and I have > nothing after grub loaded kernel and initrd. > > Cheers, > Guillaume > > >> >> Regards, >> Matthias >> >> [1] https://en.opensuse.org/HCL:Raspberry_Pi >> [2] >> openSUSE-Tumbleweed-ARM-JeOS-raspberrypi.armv6l-2019.10.25- >> Snapshot20191101.raw.xz >> -- >> To unsubscribe, e-mail: [email protected] >> To contact the owner, e-mail: [email protected] > > IMPORTANT NOTICE: The contents of this email and any attachments are > confidential and may also be privileged. If you are not the intended > recipient, please notify the sender immediately and do not disclose the > contents to any other person, use it for any purpose, or store or copy the > information in any medium. Thank you. > -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
