On Wed, Aug 22, 2007 at 11:09:37PM +0200, James PEARSON wrote: > Resume of my problems to date; > 1- Network Configuration problems on install on T60 Thinkpad
I guess you are missing the iwl3945-ucode, which has not been installed automatically. (This also happend on my X60 -- this problem is under investigation.) > 2- SaX2 incorrectly configured Intel 945 GM video card Known issue -- a fixed package is already internally available and will be released as an online update soon. Best, Christoph > ########################################################### > # 1 Network Configuration problems on install on T60 Thinkpad > ########################################################### > > Network Configuration Window (during install) > > General Network Settings > Network Mode: Interfaces controlled by NetworkManager > > Network Interfaces (Network Configuration Window) > * Wireless Network Card # (<= no Device name; Unable to configure network > card because > kernal device is not present) Not configured yet > > * Unknown Network Device # (<= Device name is eth-eth0 ; Module name under > Configure/Hardware window is e1000) Configured with DHCP > > * Unknown Network Device # (<= Device name is eth-eth0 ; no Module name > Configure/Hardware > window ) Configured with DHCP > *Loopback Device > > Configured with address 127.0.0.1 (losthost) > > > Remark 1: Wireless card is an Intel PRO/Wireless 3945ABG. I know that there > is a bug out on > this for Beta1 (don't recall the number though) > > Remark 2: I noticed no changes in the Network Interfaces settings (Network > Configuration > Window) if I opted for Traditionnal network setup with NetControl. > > Remark 3: Internet (eth0) worked up to (around) this point because I d/l and > installed > several extra rpms during the install and the eth0 worked on first boot. > > Remark 4: Despite the fact that lsmod | grep ipw3945 lists the following (see > below) my > wireless card is not seen by yast > > ipw3945 > ieee80211 > firmware_class > > > ########################################################### > 2- SaX2 configuration > ########################################################### > SaX2 had configured the Intel 945 GM video card with a resolution of 1024x768 > (XGA) with a > monitor LEN LENOVO LCD MONITOR but the resolution I getting (was I believe) > was more like > 800 x 640 XGA. > > When I ran SaX2 - it said 1024x768 (XGA) but when I tested it (no changes > were made) it > said 800 x 640 XGA. > > Hope this helps > > Regards > James -- Christoph Thiel, Tech. Project Management, Research & Development SUSE LINUX Products GmbH, GF: Markus Rex, HRB 16746 (AG Nürnberg) --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
