peter nikolic wrote:
On Sunday 23 September 2007, Donn Washburn wrote:
Hey Group;
SuSE 10.3 Beta2
I use runlevel 3 just for info. I have recently had a problem with my
printer which was found readily by Yast2. The problem is that every
time I go to print I needed to run Yast2. I think I have found the
problem. In /etc/init.d/rc3.d there is mentioned in the README a S20lpd
linked to ../lpd. But there is no ../lpd script. The README mentions
"/etc/init,d/lpd start" and "/etc/init,d/lpd stop" but there is no lpd
script.
lpq sees a print job waiting. lprm will remove so cups seems to be OK
Printing is done by cups AFAIK in 10.3a* no lpd script in /etc/init.d on
this box and printing works no problem
Pete
Thanks Pete;
Well then check out their README in /etc/init.d which say "lpd start"
and any note about rc#.d which shows ../lpd. Which is not even in
/etc/init.d. And if anyone can explain why Yast2>Hardware>Printer has
to be run to get it to print. It may be a problem with Yast2 are
/etc/sysconfig not getting set.
--
73 de Donn Washburn
307 Savoy Street Email: " [EMAIL PROTECTED] "
Sugar Land, TX 77478 LL# 1.281.242.3256
Ham Callsign N5XWB HAMs : " [EMAIL PROTECTED] "
VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg
BMW MOA #: 4146 - Ambassador
" http://counter.li.org " #279316
Did you know?
The transistor was invented by three white men.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
